![]() ![]() Take a look at some of our related articles below. However, if the rivet does not insert easily, you can try the slightly larger #10 drill bit. The table above shows the drill bit size for various rivet sizes. It is important to use the correct drill bit size for the rivet in order to ensure a secure fit. This is a standard size and can be found in most hardware stores. You might prefer to use a #11 drill bit first, and if you find the rivets make a good tight fit, then you can use the same for the other holes. For a 3/16 pop rivet, the required drill bit size is 5/32. The #10 drill bit is slightly larger than the #11 drill bit. īoth these sizes should give you an adequate-sized hole for inserting the 3/16 rivet. As you can see in the highlighted row, if you’re going to use a rivet with a diameter of 3/16”, you have two options:Į ither use a #10 (0.194 or 0.1935 to be exact ) drill bit or a #11 (0.191) drill bit for a 3/16 rivet. The chart above gives the recommended drill bit sizes for a range of standard rivet sizes. ![]() Once inserted, the rivet will then expand to fill the gap tightly. Categories Double Ended Drill Bits, Double Ended General Purpose Drill Bits. However, the drill size of the nuts will be similar to the other one. 3/16 general purpose drill bit, double ended, 135° split point, hi-speed steel, black surfaced. Moreover, one can install the nuts using torque-controlled hand power tools. Featured for the same thing but with a little bit of modern technology. This one is the updated version of the Plusnut. That is, the drilled hole must be slightly larger than the rivet’s diameter, enough so that the rivet can slide into the hole quickly. Rivet Plusnut pre-bulbed drill bit size in inches. The general rule of thumb to determine the appropriate drill bit size for a particular rivet is to allow up to six-thousandths of an inch extra in diameter (usually 4-6/1000”). Rivet diameters are expressed in 1/32 of inch increments and their lengths in 1/16 increments. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |